APC USB TO SERIAL SMART SIGNALING CABLE DRIVER

Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of service , privacy policy and cookie policy , and that your continued use of the website is subject to these policies. I did manual arp entry to reach out to as per these instructions. Page 1 of 1 19 items. This website may contain content submitted by users and is for informational purposes only. This is the C model: Well, it may be proprietary in the sense of it being a non standard pinout , but you can find pinout diagrams if you know what you are looking for, and if you have a few inexpensive tools, you can also make one.

Uploader: Faular
Date Added: 22 April 2017
File Size: 29.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 69679
Price: Free* [*Free Regsitration Required]

By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service.

APC AP USB to Serial Smart Signaling Cable | eBay

Shouls i use the USB to serial cable afterwards then? StruxureWare for Data Centers.

It should’ve been included in your lit kit with the UPS. Alternatively, you can leave the battery disconnected for minutes and it will happen as well.

I have calbe that serial to serial should work. I assumed it was licenced software. Note that given that it’s Cablr, it’s unlikely that you’d break anything if you got it wrong anyway – is pretty robust. This A is just a USB to serial adapter and does not do any of the signaling – just converting. I need to test using a laptop with serial port connection i imagine. To do that, you need to disconnect everything including serial cableand then turn off and disconnect any load.

  EEE PC 1000HA WIRELESS DRIVER

Signaoing all fails miserably! Choose a location discussion: However, I have here in hand a Cisco YC Cable that looks like it could work, but I am having hard time trying to find the wire configuration to see if they would match up.

Do you see the device listed in device manager assuming this is Windows?

The documented pinout looks like a simple null-modem cable swapping the TX and RX pins:. Well, to begin, 9.

What communications cable is needed with my Smart-UPS and PowerChute Business Edition?

So we disconnect everything and then drain any residual power from the device. Here is the rear of the UPS: Long story short, I was able to configure network adapter using telnet.

Server Fault works best with JavaScript enabled. I may try and re-install PCBE 9.

We need to get the USB to serial adapter installed first and make sure its recognized before we go further. Well, it may be proprietary in the sense of it being a non standard pinout apd, but you can find pinout diagrams if you know what you are looking for, and if you have a few inexpensive tools, you can also make one.

  CALLAWAY BIG BERTHA DIABLO 10 DEGREE DRIVER DOWNLOAD

Part is printed on one of the connectors. Steps attempted thus far: Let us know if you have any further issues.

USB to serial adapter

First, not sure if this question belongs here or SU, so please advice accordingly before wildly down-voting or blasting me. Cable type is shielded 28AWG. Sign up using Facebook. Here’s a fairly simple one: Chad Harrison 3, 10 22 Because we inhereted the UPS unit, this smart-signalling cable is nowhere to be found.

Hmmmmm, i still cannot seem to establish a connection? You can also verify everything still shows in Device Manager.

For this UPS, then you have to disconnect the battery on it and you can hold down the off button for seconds so we can discharge the UPS completely and ultimately do the braindead. I then installed PCBE agent 9.